Downloads

Download the latest version of LV10-MC.exe Software
NOTE: version 5.28 and up requires a parameter input from the user. Please read the instructions below!

Version 5.31

What's new?

1. Function added between a G01 and G00 command to allow exact stop after G01.
2. Function added between G01 and G01 command to allow exact stop when cut angle is less than 100 degrees.
3. 0.5 second filter added when an Error input is applied to avoid sudden stops due to noise when using PLCs

Version: 5.3

What's new?

1. Spindle model can be specified at the Parameters window and the machine adjusts the tool changer function according
    to the "Spindle decceleration ratio" parameter. For Colombo spindles use 1000. For Levil spindles use 10,000 (default).
2. Automatic tool change disabled for non-ATC spindles.
3. Machine model parameter was removed
4. Default Tool Length Offsets were set to zero.
5. Tool Clamped function adjusted to allow more time before displaying warning message
6. Error message is now displayed when trying to get a tool number that exceeds the specified max number of tools.

Version: 5.28

What's new?

1. Machine axis can only be homed in the correct direction* (specified by the Home Direction parameter)
    2. M31,M32 and M33 codes were added. Insert before end of program (M30).
            M31: RESETS then Loads program1 from the Program List window.
            M32: RESETS then Loads program2 from the Program List window.
            M33: RESETS then Loads program3 from the Program List window.
    3. Touch-Sensor Input (audio jack) can now be used for Door-Interlock purposes. Switch must be normally closed.
    4. Reading variables bug removed. Read-Line filter condition deleted.
    5. HOLD PROG function enhanced to stop immediately.
    6. Faster 3D machining
    
* In order for the machine to home in only one direction, users must specify the home direction at the parameters' window. 
1. Open Parameters window (Ctrl + P) 
2. Enter your password and click on each Axis button (Axis0 to Axis 2) to update the Home Dir parameter.
For LV350D users:                    For WL400 users:
Axis0 Home Dir = 1                    Axis0 Home Dir = -1
Axis1 Home Dir = -1                   Axis1 Home Dir = 1
Axis2 Home Dir = 1                    Axis2 Home Dir = 1 
Axis3 (4th axis) = 1 or -1